At Ferrari Costruzioni Meccaniche, the most modern technology is used to give the highest possible quality standards whilst maintaining the best cost effectiveness. 


                                                                               Painting system

The piece to be painted is hung on a chain conveyor which is driven along the whole painting cycle and the speed of the chain conveyor is 33 cm / min.
The first step of the painting cycle consists of removing the grease from the piece to be painted.
This is done by placing it in a bath of phosphate grease remover at 45°C.
The piece is then rinsed by a jet of water at room temperature and dried ina furnace at temperature between 120 °C and 140 °C, with a thermic power of 250.000 Kcal/h.
At this point the piece is sprayed with a powder which is then fixed by cooking ina furnace at a temperature of 185 °C - 190 °C with a maximum thermic power of 570.000 Kcal/h.
Out of the furnace, the piece is allowed to cool and then checked by an operator for spray quality.
Any colour can be used with this painting system; generally the pieces are red or blue.


                                                                                                 
                                                                                                Plasma plate cutting

This machine cuts the pieces which make up the Ferrari palnters. A plate (1500 x 3000) mm is placed on the cutting bed and it is kept in place by another pre - plate. The working centre and torch make high precision cuts via a computer controlled link. Generally the plate is betwqeen 2 and 12 thick, but it is possible to use thinner plate (0,8 mm) ot thicker plate (up to 20 mm).



 
In our factory there are also automatic machines for drilling, threading, boring ...

The welding processes are carried out robotically on a special isle. 

These processes all contribute to Ferrari’s concept of using the best quality products with the most modern production processes to achieve the best end product.



Amoung the numerous recognitions , Ferrari costruzioni Meccaniche was awarded in 2002 the technical novelty prize for the self - propelled steam sterilizer machine.



The project of the machines is carried out in our technical office using CAD system for plane and solid modelling.



Business relations are held in our sales department.



In the picture here below you can see our meeting room.